DI-UMONS : Dépôt institutionnel de l’université de Mons

Recherche transversale
Rechercher
(titres de publication, de périodique et noms de colloque inclus)
2016-06-27 - Article/Dans un journal avec peer-review - Anglais - 6 page(s)

Equeter Lucas , Letot Christophe, Serra Roger, Dehombreux Pierre , "Estimate of Cutting Tool Lifespan through Cox Proportional Hazards Model" in IFAC-PapersOnLine, 49, 28, 238-243

  • Edition : Elsevier, Kidlington (United Kingdom)
  • Codes CREF : Probabilités (DI1132), Mécanique (DI1240), Mécanique appliquée générale (DI2100), Usinage (DI2131), Processus stochastiques (DI1131), Statistique appliquée (DI1133)
  • Unités de recherche UMONS : Génie Mécanique (F707)
  • Instituts UMONS : Institut des Sciences et du Management des Risques (Risques)
Texte intégral :

Abstract(s) :

(Anglais) An important proportion of the cost of machined mechanical elements emanates from the cost of cutting tools inserts. A large part of these costs is due to improper maintenance decisions. In this paper, we demonstrate the use of a gamma process tool wear simulation for providing tool lifetimes at several cutting speeds. We show the use of a survival model (Cox Proportional Hazards model) on turning cutting inserts, using the cutting speed as covariate. Contrary to other approaches, the Proportional Hazards model is not used to produce the parameters of a reliability model, but the Mean Up Time is rather computed through the integration of the raw survival model reliability baseline. Additional simulated data is used to validate the model. The importance of a proper distribution of the PH model tting data is highlighted by the experimental results.

Identifiants :
  • DOI : 10.1016/j.ifacol.2016.11.041